Auto track call for oxigen [done 5.27]

Number of posts : 11 Registration date : 2012-05-15

Chrono can sense if a car is on track or not. So can pclc not sense the same and do an automatic track call if the car dissapears from the rails?

Subject: Re: Auto track call for oxigen [done 5.27] 8/6/2013, 22:41

Automatic and manual trackcall for oXigen done in version 5.27 , more information at www.pclapcounter.be

Number of posts : 11 Registration date : 2012-05-15

Hey Guy

Some comments (dont know if these are new demands):

Automatic track call - can that be made in less increments than 1 sec (0,1 intervals)?

The manual track call from the Oxigen handset did not work at all eventhough driver had track call enabled. Is there any other other option or check to enable it?

Thanks
Jonas

Subject: Re: Auto track call for oxigen [done 5.27] 10/6/2013, 20:50

0,1 interval is not possible because the oXigen send the data with a delay of 0,5 sec.
About manual track call, are you sure that your hand controller firmware is at version 2.14 ?
Also there is some situation where the trackcall is not accepted (in pit lane, during race start countdoxn and during race pause).

Guy

Number of posts : 11 Registration date : 2012-05-15

Controller at 2.14, car at 2.09. The manual track call (car off track, keep brake button pressed) do not trigger a trackcall. I tried different controllers and with the automatic track call on/off with no luck - any suggestions?

Subject: Re: Auto track call for oxigen [done 5.27] 10/6/2013, 23:26

In the throttle window , the trackcall column is yellow ?
Normally the trackcall column should be yellow when oXigen send a trackcall like here:
Auto track call for oxigen [done 5.27] Throttle_o2

Auto track call for oxigen [done 5.27] Throttle_o2

» Trackmate interface - Track Call - Minimum time between track calls
» Automatic track call [Done 5.19]
» Track call on PB Pro
» TRACK CALL
» TRACK CALL PENALTY